We are searching data for your request:
Upon completion, a link will appear to access the found materials.
ancient cedar tree image by PHOTOFLY from Fotolia.com
Cedar posts have been used as fence posts for centuries. You will also need basic tree felling knowledge before attempting to accomplish this task.
Choose only straight standing cedar trees, with single trunks, to cut for posts. Wear heavy gloves and long sleeves to avoid skin irritation from the cedar bark and sap.
Measure the trunk at eye level. The trunk should be between six and eight inches across to make a long-lasting, sturdy fence post.
- Cedar posts have been used as fence posts for centuries.
- If you are cutting down your own cedar trees for use as posts, keep in mind that you will need to let them cure, or dry, for at least a year before use.
Cut the tree, with the chainsaw, approximately two feet above the ground using safe, tree-felling procedures.
De-limb the trees of the branches as close to the trunk as possible using the chainsaw. Cut the logs to the desired length. Six to eight feet are the normal post lengths.
Sacrifice two of the posts as racks and keep the remaining posts off the ground. Stack the posts, rick style, and allow them to age for one year.
Knock away the loose bark from the dried cedar after the first year, using a mallet or hammer. The posts are now ready to be used as fencing.
- Cut the tree, with the chainsaw, approximately two feet above the ground using safe, tree-felling procedures.
Red Cedar As Fence Posts
Dig a hole for each post using a post-hole digger. Make its depth equal to half the height of the fence, or one-third of the total length of the post. Make a mark on the bottom of the post to denote ground level. Remove the entire covering of white wood from the red heartwood core. Put enough gravel into the hole to make a 2-inch layer on the bottom and drop in the post. Fill the hole with about 6 inches of gravel, then level the post with a level and tamp the gravel with a 2-by-4-inch piece of scrap wood. Finish filling the hole with concrete. Use post holders only with 4-by-4-inch or 4-by-6-inch posts. If the posts are cylindrical, it's better to bury them. Fill the hole to ground level with concrete.
- Dig a hole for each post using a post-hole digger.
- Fill the hole with about 6 inches of gravel, then level the post with a level and tamp the gravel with a 2-by-4-inch piece of scrap wood.
When standing cedar posts for fencing, allow the posts to be buried 18 inches to two feet into the ground for better stability.
If clearing a property of cedar, larger cedar logs can be taken to a sawmill and turned into cedar lumber. The smaller top of the trees can be used for posts.